Nad | Phono Preamp Pp2 Manual

Ensure the turntable's ground wire is securely attached to the PP 2 .

: If your turntable has a separate ground wire, secure it to the GND thumb screw on the back of the PP 2 to minimize hum. Nad Phono Preamp Pp2 Manual

The PP 2 utilizes high-quality components and a 24V power supply for enhanced musical dynamics and stability. Moving Magnet (MM) Moving Coil (MC) Gain at 1kHz Input Sensitivity 3.5mV (ref. 200mV output) 0.2mV (ref. 200mV output) Signal-to-Noise Ratio 80dB (A-weighted) 78dB (A-weighted) RIAA Accuracy ±0.3dBplus or minus 0.3 d cap B ±0.3dBplus or minus 0.3 d cap B THD (20Hz - 20kHz) Source: NAD PP-2 Specifications . 3. Troubleshooting Ensure the turntable's ground wire is securely attached

: Use RCA cables to connect the PP 2 Output to a Line-Level input (e.g., CD, AUX, Tuner) on your receiver. Moving Magnet (MM) Moving Coil (MC) Gain at

: Never connect the PP 2 to an input marked "PHONO" on your receiver, as this will cause severe distortion.

Move the PP 2 away from other equipment (like power transformers) to reduce interference.

Check if the . If not, verify the power supply connections. Ensure the correct input is selected on your amplifier. Hum or Buzz :